P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum

Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t

First layer not good on Bambulap P1P - Bambu Lab P1 Series - Bambu Lab Community Forum

Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800

Top Layer Issues - Troubleshooting - Bambu Lab Community Forum

Learning 3D printing - Langmuir Systems Forum

Chamber Fan Duct for P1P/P1S (no support) by suit1337 - MakerWorld

Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800

Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800

Bambu Killing 3D Printers: Before and After the Bambu Lab Desktop 3D Printer

P1P First Layer Struggles, Plz Help : r/BambuLab

Bambu Lab P1P Review

Bambu Lab P1P P1S X1C X1E Spring Steel Build Plate With Configurable Top garolite, G10, Carbon Fiber

New p1p first layer issues. : r/BambuLab

Bambu lab hardware - Bambu Lab P1 Series - Bambu Lab Community Forum, g1 f1800