First Layer Issues - Troubleshooting - V1 Engineering Forum

Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin

First layer issues – Assembly and first prints troubleshooting

First layer issue – Assembly and first prints troubleshooting

3D print improvements - Troubleshooting - V1 Engineering Forum

cdn./wp-content/uploads/First-Laye

Perfect first layer issues – Assembly and first prints

First Layer Issues : r/FixMyPrint

First Print - Troubleshooting - V1 Engineering Forum

V1 Engineering Inc -V1E.com

First layer issues - Page 2 – Assembly and first prints

First layer issues – Assembly and first prints troubleshooting

Well, I'm getting started! - Troubleshooting - V1 Engineering Forum

Myriad of First Layer Issues {MK3S+} : r/prusa

Troubleshooting 3D prints, first layer issues

First Layer problems - Inconsistency – Assembly and first prints